Pete
asked on
MDT 2013 and UEFI
I have had a working MDT deployment (6.3.8443) environment for a year or so but now I have my first UEFI only computer, I have added all the latest win7x64 drivers to the task sequence (chipset, VGA, LAN etc etc) and there is a (built-in) task step "Format and Partition Disk (UEFI)" which formats the drive as GPT, this applies correctly when I run the task sequence.
The sequence finishes imaging the computer but on first boot to Windows it hangs at the 'Starting Windows' logo.
Safe mode hangs at CLASSPNP.sys
Any ideas?
The sequence finishes imaging the computer but on first boot to Windows it hangs at the 'Starting Windows' logo.
Safe mode hangs at CLASSPNP.sys
Any ideas?
ASKER
The fix was to enable CSM in the BIOS.
Thanks though.
Thanks though.
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
Ok sorry, I agree. I did so much reading around this I lost track of where the info was finally found.
dj 3094 totally deserves points.
Thanks
dj 3094 totally deserves points.
Thanks
I am glad, that link helped you.
You can choose the solution and close it.
You can choose the solution and close it.
https://www.sevenforums.com/installation-setup/295809-windows-7-hangs-start-logo.html
https://social.technet.microsoft.com/Forums/en-US/cb2f0faa-92f8-444c-a4d8-070829d1770d/stuck-at-starting-windows-after-deployment?forum=mdt
I upgraded bios
set UEFI
cleaned disk
deploy
hope this might help you