I dont know which interface to check and configure ip, are the module compatible i got an error when first inserted
Router#sh ip int brief
Interface IP-Address OK? Method Status Protocol
GigabitEthernet0/0/0 203.89.212.150 YES manual up up
GigabitEthernet0/0/1 10.194.2.1 YES manual up up
GigabitEthernet0/0/2 unassigned YES unset administratively down down
GigabitEthernet0/0/3 unassigned YES unset administratively down down
Service-Engine0/2/2 unassigned YES unset administratively down down
Service-Engine0/4/0 unassigned YES unset administratively down down
GigabitEthernet0 unassigned YES unset administratively down down
BRI0/2/0:1 unassigned YES unset down down
BRI0/2/0:2 unassigned YES unset down down
BRI0/2/0:0 unassigned YES unset up down
BRI0/2/1:1 unassigned YES unset down down
BRI0/2/1:2 unassigned YES unset down down
BRI0/2/1:0 unassigned YES unset up down
Vlan1 unassigned YES unset administratively down down
When module is inserted :
*Mar 29 05:52:48.649: %TRANSCEIVER-3-NOT_SUPPORTED:iomd: Detected for transceiver module in Gigabitethernet0/0/1, module disabled
*Mar 29 05:52:51.214: %LINK-3-UPDOWN: Interface GigabitEthernet0/0/0, changed state to down
*Mar 29 05:52:52.214: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet0/0/0, changed state to down
Our community of experts have been thoroughly vetted for their expertise and industry experience.
The Distinguished Expert awards are presented to the top veteran and rookie experts to earn the most points in the top 50 topics.