Dwci
asked on
Drobo B1200i and vmware ESX 5.5 with two servers
I have two HP servers with one 12TB Drobo that I am trying to get the vmware to see the drives on the Drobo. Are there any tidbits anyone can give me on getting the second server seeing the data drive?
ASKER
Andrew just not doing something right. Get a message "The iSCSI initiator could not establish a network connection to the target". does that me an I don't have something setup on the DROBO correct?
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
I am not seeing where that is. What am I missing?
okay do you see the LUN for the Drobo under storage devices ?
ASKER
No I do not see the LUN for the Drobo under storage.
Okay, have you configured your storage network, and iSCSI correctly on this host, can you see if this host is connecting and reaching the Drobo unit ?
ASKER
Ho do I do that?
Okay, you configure the host as below
HOW TO: Add an iSCSI Software Adaptor and Create an iSCSI Multipath Network in VMware vSphere Hypervisor ESXi 5.0
HOW TO: Enable Jumbo Frames on a VMware vSphere Hypervisor (ESXi 5.0) host server using the VMware vSphere Client
samer procedure for 5.5, although I wrote these articles for 5.0!
let me know, when your hosts are configured as above, and make sure your networking and Drobo are configured for Jumbo Frames.
HOW TO: Add an iSCSI Software Adaptor and Create an iSCSI Multipath Network in VMware vSphere Hypervisor ESXi 5.0
HOW TO: Enable Jumbo Frames on a VMware vSphere Hypervisor (ESXi 5.0) host server using the VMware vSphere Client
samer procedure for 5.5, although I wrote these articles for 5.0!
let me know, when your hosts are configured as above, and make sure your networking and Drobo are configured for Jumbo Frames.
ASKER
I have one thing that doesn't look correct on the new VMWARE server WWN is set to iqn.2005-06.com.drobo:drb1 4110100000 59.id1 and the old one is set to iqn.1998-01.com.vmware:dwc esx1-0206c 631 any clue how I get the new one looking like that?
iqn.2005-06.com.drobo:drb1 4110100000 59.id1
iqn.1998-01.com.vmware:dwc esx1-0206c 631
The iSCSI Software adaptor - WWNN is auto generated, when it's enabled
Can you obtain some screenshots ?
iqn.1998-01.com.vmware:dwc
The iSCSI Software adaptor - WWNN is auto generated, when it's enabled
Can you obtain some screenshots ?
ASKER
I got it I believe thanks andrew for all the help.
not a problem!
Re-scan the iSCSI Storage adaptor, and the Datastore should appear!