troubleshooting Question

DC dynamic port change?

Avatar of snyderkv
snyderkv asked on
Active Directory* domain controller
1 Comment1 Solution111 ViewsLast Modified:
EE,

Thanks for reading. I read documents on dynamic ports on domain controllers but confused on how to go about changing them to specific ports.

We have blocked high level ports on our network firewalls and will no longer use 49k-65k dynamic range for RPC or whatever the DCs use it for i.e. replication etc

The question is how to change the dynamic range to the range we have allowed?

netsh int ipv4 show dynamicport udp (shows default)

Thanks again
ASKER CERTIFIED SOLUTION
Aard Vark
Principal Engineer

Our community of experts have been thoroughly vetted for their expertise and industry experience.

Join our community to see this answer!
Unlock 1 Answer and 1 Comment.
Start Free Trial
Learn from the best

Network and collaborate with thousands of CTOs, CISOs, and IT Pros rooting for you and your success.

Andrew Hancock - VMware vExpert
See if this solution works for you by signing up for a 7 day free trial.
Unlock 1 Answer and 1 Comment.
Try for 7 days

”The time we save is the biggest benefit of E-E to our team. What could take multiple guys 2 hours or more each to find is accessed in around 15 minutes on Experts Exchange.

-Mike Kapnisakis, Warner Bros