Bob Brown
asked on
Cisco 2960 / 3560 Reset password - Using the Mode button on switch
I am attempting to reset the password on a Cisco 3560 switch, And I am following the steps in the "Password Recovery Procedure for the Cisco Catalyst Fixed Configuration Layer 2 and Layer 3 Switches" document and I am still having problems.
In step I3 I use enable secret examplePW1 then I use enable password examplePW2, when the switch is reloaded or booted I keep getting a login for a username.
My question is can I Reset the password and username with these commands in step 13.
enable secret level 5 password
username admin privilege 15 secret 5 cisco
In step I3 I use enable secret examplePW1 then I use enable password examplePW2, when the switch is reloaded or booted I keep getting a login for a username.
My question is can I Reset the password and username with these commands in step 13.
enable secret level 5 password
username admin privilege 15 secret 5 cisco
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER