AXISHK
asked on
NAT on Fortigate
In my Fortiage 100D, a destination NAT is configured to map a public IP address to an internal mail server through port 25, mails can received properly.
When I try telnet [public IP of mali server] 25, there is no connection.
I suppose this should be work or SMTP connection cannot be established. If this is not established, mails can't be recevied. However, mails can pass through so far.
I try to run port scanner on the public IP of mail server, it can't scan any port except 443. In fact, port has opened for 25, 80, 143 & 110 for this server.
So, should I miss some settings in Fortigate ?
Thx
When I try telnet [public IP of mali server] 25, there is no connection.
I suppose this should be work or SMTP connection cannot be established. If this is not established, mails can't be recevied. However, mails can pass through so far.
I try to run port scanner on the public IP of mail server, it can't scan any port except 443. In fact, port has opened for 25, 80, 143 & 110 for this server.
So, should I miss some settings in Fortigate ?
Thx
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER