chestera
asked on
GA Ribbon creator
Hi EE
I am using GA Ribbon creator. My question is at the moment after creating a ribbon I go to access modules basRibbonCallBacks then to OnActionButton here I enter against each button a Docmd.Openform "frmForm". Is there away while in GA RibbonCreator to add the form after creating a button or is the way I am doing it the only way
chestera
I am using GA Ribbon creator. My question is at the moment after creating a ribbon I go to access modules basRibbonCallBacks then to OnActionButton here I enter against each button a Docmd.Openform "frmForm". Is there away while in GA RibbonCreator to add the form after creating a button or is the way I am doing it the only way
chestera
John Tsioumpris
GA Ribbon Creator is a paid product with support...i am afraid i am not aware of its functionality but i guess for start you should contact the author.
ASKER
John Tsioumpris
Thank you I will but thought EE might know it's hard to contact some of these vendors.
Alan
Thank you I will but thought EE might know it's hard to contact some of these vendors.
Alan
SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
DatabaseMX
Hi Joe
After creating the Tabs Groups and in my case Buttons I go to Finish save then exit. Then I open Access Modules and select basRibbonCallbacks, OnActionButton,I get Button0 button1 etc with in German "button has been selected". I replace this message with
Docmd.Openform "frmForm" and go through all the buttons adding the required form
My question, is there away to do this within Gunter's Ribbon Creator as buttons are added
Hope this makes sense
Alan
Hi Joe
After creating the Tabs Groups and in my case Buttons I go to Finish save then exit. Then I open Access Modules and select basRibbonCallbacks, OnActionButton,I get Button0 button1 etc with in German "button has been selected". I replace this message with
Docmd.Openform "frmForm" and go through all the buttons adding the required form
My question, is there away to do this within Gunter's Ribbon Creator as buttons are added
Hope this makes sense
Alan
SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
Alan, did you saw the link above?
ASKER
Bitsqueezer
Yes I got the Link above thank you
Alan
Yes I got the Link above thank you
Alan
ASKER
Scott McDaniel
That you Scott
Alan
That you Scott
Alan