amigan_99
asked on
Proper Shutdown Cisco UCM on UCS C200
I need to move a call manager which is a VM on a UCS C200. Can you please advise
on the proper shutdown procedure and the turn-up? It will retain IP address etc.
Just need to make sure I don't corrupt anything. I see a shutdown procedure
below for CIMC and using the power button. But should I also ssh to Call Manager
first and shut there as well? Thank you.
http://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/c/hw/C200M1/install/c200M1/replace.html#wp1053068
on the proper shutdown procedure and the turn-up? It will retain IP address etc.
Just need to make sure I don't corrupt anything. I see a shutdown procedure
below for CIMC and using the power button. But should I also ssh to Call Manager
first and shut there as well? Thank you.
http://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/c/hw/C200M1/install/c200M1/replace.html#wp1053068
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
You're welcome!
ASKER