Start Free Trial

asked on

Cisco SF300 24 Port 10/100 Managed Switch Static Route problem

Hi Experts,

I am having a problem adding a static route on the cisco sf300 switch. I keep getting an error message,

29-May-2017 09:21:58 %IPROUTETABLE-A-ROUTETABLEOVERFLOW: IP routing table overflow: failed to add route address 10.207.26.160, mask 255.255.255.240, nexthop 10.194.x.2

I trying the add the following static route

ip route 10.x.26.100 255.255.255.240 10.194.x.x

Any help will be greatly appreciated.

Regards,

M

Is the switch in layer 2 mode, or layer 3 mode?

ASKER

Its in layer 3 mode

ASKER CERTIFIED SOLUTION

membership

This solution is only available to members.

To access this solution, you must be a member of Experts Exchange.

Start Free Trial

SOLUTION

membership

This solution is only available to members.

To access this solution, you must be a member of Experts Exchange.

Start Free Trial

SOLUTION

membership

This solution is only available to members.

To access this solution, you must be a member of Experts Exchange.

Start Free Trial

SOLUTION

membership

This solution is only available to members.

To access this solution, you must be a member of Experts Exchange.

Start Free Trial

SOLUTION

membership

This solution is only available to members.

To access this solution, you must be a member of Experts Exchange.

Start Free Trial

SOLUTION

membership

This solution is only available to members.

To access this solution, you must be a member of Experts Exchange.

Start Free Trial

SOLUTION

membership

This solution is only available to members.

To access this solution, you must be a member of Experts Exchange.

Start Free Trial

ASKER

Thank you, David, for your help

Glad I could help.