Member_2_7349958
asked on
How to configure etherchannel
I have cisco 3650 and 3560G connected one to one port as trunk. Ports are gig1/1/1 to g0/1
What is the recommended etherchannel configuration from port gig1/1/1, gig 1/1/2 to g0/1, g0/2?
What is the recommended etherchannel configuration from port gig1/1/1, gig 1/1/2 to g0/1, g0/2?
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
You can configure both sides as active, as long as both sides are not passive etherchannel will be OK. Active on one side and passive on the other side is recommended configuration. Etherchannel negotiation process is a little faster when sides are configured as active - passive.
ASKER
Ok. So I have 3650 as the core switch(MDF) and 4 other as 3560G (IDF) connected to the core switch as trunk. So I have use the same active-passive configuration for MDF(active) & IDF(passive), correct?
Yes.
I would recommend you to check 3650 and 3560G Caveats regarding etherchannel (there were some problems with etherchannel in some IOS versions on some models).
3650 Caveats
3560 Caveats
I would recommend you to check 3650 and 3560G Caveats regarding etherchannel (there were some problems with etherchannel in some IOS versions on some models).
3650 Caveats
3560 Caveats
ASKER
My goal is to achieve more bandwidth. With this will I be able to get 2Gpbs as both the ports are 1gbE?
SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER