DP230
asked on
Question about configurations on Cisco router 3925
Dear zealots, I am configuring Routers and Switch to mitigate DDoS attacks, following this article: http://www.infosecwriters.com/Papers/HChau_Cisco-DoS-DDoS.pdf
However, when I enter "no ip directed-broadcast" into Router and Switch's interface mode, then it cannot be displayed when I hit "show run". Do you know why? My devices' version is 12.2 (Switch 3750/3560) and 15.1 (Router 3925)
And should I apply this command on VLAN interfaces in Switches?
However, when I enter "no ip directed-broadcast" into Router and Switch's interface mode, then it cannot be displayed when I hit "show run". Do you know why? My devices' version is 12.2 (Switch 3750/3560) and 15.1 (Router 3925)
And should I apply this command on VLAN interfaces in Switches?
SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
R2#sh run | i version
version 15.1
ip ssh version 2
.....
R1#sh run | i version
version 15.2
ip ssh version 2
Even on these routers, I could run "no ip directed-broadcast" on interface config mode, but could not find them in "show run'' 's result. Do you know why?
version 15.1
ip ssh version 2
.....
R1#sh run | i version
version 15.2
ip ssh version 2
Even on these routers, I could run "no ip directed-broadcast" on interface config mode, but could not find them in "show run'' 's result. Do you know why?
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER