How to connect to printer with old/bad SSL settings (Need to use SSL with DES)
In trying to get scan to email working I was changing settings in the kyocera cs400ci printer and now locked myself out of the GUI as the SSL settings I set it to are wrong and browsers dont trust it.
I checked SSL and DES only (no 3DES or AES) and now all browsers say invalid/bad/unsupported ssl/tls etc.
Any ideas on how I can ignore any/all ssl warnings and still get to the gui? force ssl is on so I cant use port80.
I checked SSL and DES only (no 3DES or AES) and now all browsers say invalid/bad/unsupported ssl/tls etc.
Any ideas on how I can ignore any/all ssl warnings and still get to the gui? force ssl is on so I cant use port80.
If all else fails, you can always try a factory reset. The following may do it:
1. Press to select Menu.
2. Select Settings » Security.
3. Enter your 4-digit lock code (typically 0000).
4. Select Reset
5. Select Yes to erase
1. Press to select Menu.
2. Select Settings » Security.
3. Enter your 4-digit lock code (typically 0000).
4. Select Reset
5. Select Yes to erase
Which browser are you using? If Chrome, depending on the message, you can click Advanced then Proceed.
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
Advanced settings enable older versions/protocol.