Asfour Crystal
asked on
nslookup not working
hello,
i've actibe on win 2012 r2 (3 DCs) and installed dns on it, and dhcp on other win2008 r2 server when i run nslookup command to get the hostname of pc ip i got an error like that:
primary name server = localhost
responsible mail addr = nobody.invalid
serial = 1
refresh = 600 (10 mins)
retry = 1200 (20 mins)
expire = 604800 (7 days)
default TTL = 10800 (3 hours)
*** No internal type for both IPv4 and IPv6 Addresses (A+AAAA) records available
so what's the missing configuration that can fix it?
i've actibe on win 2012 r2 (3 DCs) and installed dns on it, and dhcp on other win2008 r2 server when i run nslookup command to get the hostname of pc ip i got an error like that:
primary name server = localhost
responsible mail addr = nobody.invalid
serial = 1
refresh = 600 (10 mins)
retry = 1200 (20 mins)
expire = 604800 (7 days)
default TTL = 10800 (3 hours)
*** No internal type for both IPv4 and IPv6 Addresses (A+AAAA) records available
so what's the missing configuration that can fix it?
Check the DNS settings on NIC card. Validate the DNS settings as well.
Check if reverse zone is properly configured. Make sure that you selected box to create a PTR record.
Is there any other device which is acting as DNS in between?
Is there any other device which is acting as DNS in between?
ASKER
i checked the configuration of NIC and it's ok.
about the revers zone shall i create it manually?
about the revers zone shall i create it manually?
Yes, create the reverse zone manually and wait for replication to entire domain or do force replication and then check.
ASKER
ok is their any settings that i can make while i create new dhcp scope that create its revers zone automatically?
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.