cjvawv1982
asked on
VLAN Help
Hello experts. I am trying to setup a VLAN in a test environment and I am not able to get it to work so far. I have searched this board and researched online but just can't seem to get it to work.
Right now I have two Comcast internet circuits coming into a peplink balance 20 (will be upgraded to the balance 305) I have one cat 6 patch cable going from the router lan port 1 to Switch 1, port 1. I have a total of 5 sg200 switches, all connected by 4 port LAGS and fiber.
I want to have 3 VLANS. On the peplink under LAN--->network settings I created the VLANS as 10 with an IP of 192.168.10.1 with DHCP enabled for 192.168.10.2 - 192.168.10.250, VLAN 20 as 192.168.20.1, VLAN 30 as 192.168.30.1 all with DHCP enabled. Under LAN--> port settings I have port 1 set to trunk and tagged the 3 VLANS.
I have the VLANS setup on all of the switches. On Switch 1, port 1 where the router is connected I have it set to tag the 3 VLANS I created.
On Switch 1, port 5 I have a laptop connected to test. I have that port set to access and VLAN1 to exclude, VLAN10 as untagged. From this point I am unable to get a dhcp address and if I enter a static ip I am unable to get internet access.
Is everything correctly configured so far? Right now everything is operating from the one switch. I haven't tried other ports on other switches.
What do I configure the LAGs as?
Any help will be VERY much appreciated!
Thanks in advanced,
CJ
Right now I have two Comcast internet circuits coming into a peplink balance 20 (will be upgraded to the balance 305) I have one cat 6 patch cable going from the router lan port 1 to Switch 1, port 1. I have a total of 5 sg200 switches, all connected by 4 port LAGS and fiber.
I want to have 3 VLANS. On the peplink under LAN--->network settings I created the VLANS as 10 with an IP of 192.168.10.1 with DHCP enabled for 192.168.10.2 - 192.168.10.250, VLAN 20 as 192.168.20.1, VLAN 30 as 192.168.30.1 all with DHCP enabled. Under LAN--> port settings I have port 1 set to trunk and tagged the 3 VLANS.
I have the VLANS setup on all of the switches. On Switch 1, port 1 where the router is connected I have it set to tag the 3 VLANS I created.
On Switch 1, port 5 I have a laptop connected to test. I have that port set to access and VLAN1 to exclude, VLAN10 as untagged. From this point I am unable to get a dhcp address and if I enter a static ip I am unable to get internet access.
Is everything correctly configured so far? Right now everything is operating from the one switch. I haven't tried other ports on other switches.
What do I configure the LAGs as?
Any help will be VERY much appreciated!
Thanks in advanced,
CJ
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER