Wilson Net
asked on
Margin problem with Zebra GC420T on Windows 10
I have a Zebra GC420T printer installed in Windows 10 with the seagull driver, but when printing the label it adds a left and right margin of 1 Cm (12pt).
I checked the configuration in the driver and I have not added any type of margin, same in the label that I print. Also update the printer driver but still the same.
What could be causing this problem?
I checked the configuration in the driver and I have not added any type of margin, same in the label that I print. Also update the printer driver but still the same.
What could be causing this problem?
ASKER
the problem isn't the margin per se, is the width of it on windows 10, on windows 7/8/2012 if only 0.5 cm but in windows 10 is 1.5 cm on each side of the label. i tried sending the raw command to the printer and the margin is perfect (only 0.5 cm) i think i has to be something with the printer driver
Which app are you using to create the label?
ASKER
the Bartender 10.4 with Zebra XML export
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
you're right, is the tool version on windows 10, after update to a newer version is working fine, thx
Then let's close this question. If you'd like to accept my suggestion as a solution and award points, that would be cool.
ASKER
the problem was the tool version on windows 10, the bartender 11 don`t work well on windows 10, after update to a newer version is working fine
When you see something that has print bleed (where the picture, text, or color goes right to the edge, it was actually printed on a larger sheet of paper, then the white, non-printable area was cut off.
You're not going to find any way around the non-printable area.