amigan_99
asked on
Server has Rx errors but the switch has none
Sysadmin is complaining that when traffic to his server is a little higher than usual (say 300Mbps on a 1Gbps interface) that he's seeing Rx errors on his interface. If I look at the switch that is connected to his server it shows everything clean. No errors Rx/Tx - just an increase in throughput once a day. It's a linux system. What can I advise him to do regarding errors on higher than average throughput? Anything else I could do on the Cisco switch side?
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
You are welcome.
ASKER