Jam Tim
asked on
Configure ESW-540 cisco switch as a DHCP server
Hi
Can we configure ESW-540 switch as a DHCP server with it's own address pool? Have already reviewed the manual but it doesn't seem to have this functionality.
Can we configure ESW-540 switch as a DHCP server with it's own address pool? Have already reviewed the manual but it doesn't seem to have this functionality.
ASKER
Thanks Hemil,
ESW-540 doesn't seem to be CLI, it's GUI and there is no where to configure DHCP pool in it's gui
ESW-540 doesn't seem to be CLI, it's GUI and there is no where to configure DHCP pool in it's gui
You should see a console port in the back looking like an RJ45
ASKER
Have tried this before, the console port connection will give only configuration options not CLI (almost the same options I see in gui) , This is what I found from the manual :
Q. Do the Cisco ESW 500 Series Switches have a command-line interface (CLI)?
A. No, these switches cannot be managed through a CLI.
Q. Do the Cisco ESW 500 Series Switches have a command-line interface (CLI)?
A. No, these switches cannot be managed through a CLI.
SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
That's what I said before pal, but you can relay dhcp.
That's it.
That's it.
ASKER
This model can not be used as a DHCP server
Ip dhcp pool My_DHCP
network 192.168.1.0 255.255.255.0
Default-gateway 192.168.1.1
dns server 8.8.8.8
Always use contest sensitive help