asked on

Exchange 2013 autodiscover multi setup.

Hello Experts,

I have set the autodiscover to below config .
All things working fine but wanna to know if below setup is also the correct setup for autodiscover.
We have only one entry in the DNS wich point to the adress of EXServer01.
Get-ClientAccessServer | Select Name,AutoDiscoverServiceInternalURI

Name AutoDiscoverServiceInternalUri
---- ------------------------------
EXServer01 (main site) https://autodiscover.paramelt.com/Autodiscover/Autodiscover.xml
EXServer02 (main site) https://autodiscover.paramelt.com/Autodiscover/Autodiscover.xml
EXServer03 https://autodiscover.paramelt.com/Autodiscover/Autodiscover.xml
EXServer04 https://autodiscover.paramelt.com/Autodiscover/Autodiscover.xml
EXServer05 https://autodiscover.paramelt.com/autodiscover/autodiscover.xml

Hemil Aquino

One autodiscover should be good enough if you have the same namespace. Now, it would be the opposite if you have different namespace.

How does your configuration looks like? are you running DAG?

ottenshx

ASKER

Hi , Thanks for your reply .

We have 2 mailserver in the main site that are standing in Dag group.
Then the other mailservers are located on the other site of the world and does not contain any dag group with each other nor with the mainsite dag group.
We use one name outlook.mydomainname.com for every virtual directory over all exchange servers.
We use round robin on the DNS for outlook.mydomainname.com

ASKER CERTIFIED SOLUTION

Hemil Aquino

membership

This solution is only available to members.

To access this solution, you must be a member of Experts Exchange.

Start Free Trial

ottenshx

ASKER

Got it. i will round rob these autodiscover as well.