Cheap router required for port forwarding allowing to the specific IP range

Hi

I need a cheap WAN router which would allow me to set up port forwarding in such a way that I can provide the IP range with subnet of the devices which can use this port forwarding. So far, I only found routers which only allow to specific single IP address of the remote host so if I had to input the IP range in question, I would have over 1000 entries and even that is not supported by most of the routers.
I know this may be unusual and I hope you came across such a device.
It is not a problem if I had to buy a second hand from eBay to keep the cost down.
Thanks

Regards,
Tom
Tom SkowyrskiAsked:
Who is Participating?
 
David Johnson, CD, MVPConnect With a Mentor OwnerCommented:
Can't be done it is a one to one translation (NAT) rule a vpn or an internal gateway would be a better solution.
0
 
L0k1Network AdministratorCommented:
I suggest Cisco router 1900 series, is good enough for small office
0
 
Tom SkowyrskiAuthor Commented:
Does Cisco 1900 allow for port forwarding based on IP range then? Or would I have to use something else like internal gateway with it?
0
 
David Johnson, CD, MVPOwnerCommented:
As stated NAT is a 1 to 1 relationship.
0
Question has a verified solution.

Are you are experiencing a similar issue? Get a personalized answer when you ask a related question.

Have a better answer? Share it in a comment.

All Courses

From novice to tech pro — start learning today.