8055730
asked on
Does any one know why might cause an Aruba IAP 315
Our system status LED light is ambler-blinking and according to the doc, it says it is running in restricted mode etc... We made sure the cable is running in Cat6 and the switch port sees it as full 1G. Does any know what the issue may be?
The other APs that we have are fine.
The other APs that we have are fine.
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
Figured out it was a different switch port.
1. Try a cat6 patch cable into the same port to a gigabit port in some other device (laptop, AP, etc.) If you still get the error, then you may have a bad port.
2. If (1) works, and you can pull the AP back for testing, try it using the same patch cable. If that fails, then the AP port is bad or mis-configured.
3. If (2) works, then you either have a bad cat6 cable, or the distance is too long to maintain gigabit speeds.