Leadtheway
asked on
CIsco ASA NAT issue
trying to create default nat for a 5506-x ASA and getting an error
ColoAsa(config)# nat (inside,outside) after-auto source dynamic any interface
^
ERROR: % Invalid input detected at '^' marker.
ColoAsa(config)# nat (inside,outside) after-auto source dynamic any interface
^
ERROR: % Invalid input detected at '^' marker.
That's not how you use the nat command, when you define nat you only reference the interface where the local ip addresses are accessed, not a source and destination. If you want to do a static translation between 2 different zones the command would look like this "static (inside,outside) outsideIP insideIP mask"
ASKER
its called twice nat. Its common, just not sure why its not working on the 5506 when i have it configured the exact same way on my 5512/5516
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
Issue was self-resolved