NAT translation

Hello, i wanted to modify an IP nat translation on my 2811 router but it is saying that it is in use after the command "no ip nat..."  I have read somewhere that i have to do an clear ip nat translation* command.  Will this not disconnect anything other than the one i'm trying to modify?

Thank you,
Manny
Manny MendozaAsked:
Who is Participating?
I wear a lot of hats...

"The solutions and answers provided on Experts Exchange have been extremely helpful to me over the last few years. I wear a lot of hats - Developer, Database Administrator, Help Desk, etc., so I know a lot of things but not a lot about one thing. Experts Exchange gives me answers from people who do know a lot about one thing, in a easy to use platform." -Todd S.

TjnoNetwork AdministratorCommented:
No,  you will be safe to do that

Just issue "clear ip nat translation *"

Then modify your configurations.
0
Manny MendozaAuthor Commented:
This command will be after config t?

Thanks
0
netcmhCommented:
No, you can just run it in normal mode
0
Ultimate Tool Kit for Technology Solution Provider

Broken down into practical pointers and step-by-step instructions, the IT Service Excellence Tool Kit delivers expert advice for technology solution providers. Get your free copy now.

Manny MendozaAuthor Commented:
Alright, let me give this one a shot and will update here.

Thanks
0
TjnoNetwork AdministratorCommented:
R# clear ip nat translation *
R#conf t

then modify your nat
0

Experts Exchange Solution brought to you by

Your issues matter to us.

Facing a tech roadblock? Get the help and guidance you need from experienced professionals who care. Ask your question anytime, anywhere, with no hassle.

Start your 7-day free trial
atlas_shudderedSr. Network EngineerCommented:
One other note on this.  Clearing the nat trans will only work as long as there is no traffic flowing through the rule.  If there is, the translation will just pop back in.  You may have to remove the rule to install the edits.
1
Manny MendozaAuthor Commented:
Apologies for the delay in responding. You should be able to close this topic now.

 What we have done is take out a whole set of access list and deleted the NATing and after that we put the access list back.  Then change the NATing as required.

Thank you very much for all comments/responses.
Manny
0
atlas_shudderedSr. Network EngineerCommented:
No further inputs
0
It's more than this solution.Get answers and train to solve all your tech problems - anytime, anywhere.Try it for free Edge Out The Competitionfor your dream job with proven skills and certifications.Get started today Stand Outas the employee with proven skills.Start learning today for free Move Your Career Forwardwith certification training in the latest technologies.Start your trial today
Routers

From novice to tech pro — start learning today.

Question has a verified solution.

Are you are experiencing a similar issue? Get a personalized answer when you ask a related question.

Have a better answer? Share it in a comment.