Why doesn't Spiceworks want to monitor my Kerio Control router?

Has anyone else tried to monitor their Kerio Control 3000 series with SNMP via Spiceworks?

It let's me add the device but it will not monitor any interfaces.  I know the Kerio Admin page shows all of this info, I would just prefer to have it monitored in Spiceworks with all my other servers and switches.
Brad JohnsonDirector of Information TechnologyAsked:
Who is Participating?
Mariusz J.Connect With a Mentor Technical Support SpecialistCommented:
Are you using the on-premise Spiceworks network monitor? If so, there's some bad news for ya - it's no longer developed.
Consider switching to something which is currently developed/supported. I'd recommend NetCrunch.
Brad JohnsonDirector of Information TechnologyAuthor Commented:
Thanks, I'm looking for something that is not going to cost me anything.  The on-premises works fine with my HP switches, so I will just use the Kerio's interface to monitor.  Thank you.
Question has a verified solution.

Are you are experiencing a similar issue? Get a personalized answer when you ask a related question.

Have a better answer? Share it in a comment.

All Courses

From novice to tech pro — start learning today.