asked on

Configuring HP5406 for data and voice vlans - tagging

configuring vlans on HP 5406zl
I'd appreciate some advice on configuring a data and voice vlan on a HP 5406zl, the current config is attached.
currently the whole switch is configured on the default vlan, however I want to add a voice vlan for a up coming voip phone system replacing the old analogue pabx.
the goal is to connect the pc's through the phones, phones on Vlan30 and Data on Vlan1.
I have added the vlan30 , however in need of some advice on the tagging and untagging of ports and the routing to enable the vlans to communicate with each other.
this switch also acts as the core switch and has IP routing enabled, it has 6 poe modules (ports A1- F24)
A1 to F22require both vlans , F23/F24 will be used to connect to switches on another floor and need to pass both vlans through. F17 is the link to the FW
appreciate some guidance on this as HP is not mother tongue, when switching.
current-HP-L3-core.txt

Don Johnston

First thing is I would add another VLAN for your data traffic. You really want to not use VLAN1.

Then you will tag the voice VLAN and untag the data VLAN on ports going to the phones.

On ports going to other switches you will tag both VLANs.

So with phones connected on A1- 24 and switches connected to F23 and F24 :

VLAN 10
 name "Data"
 untagged A1-24
 tagged F23-24
VLAN 30
 name "Voice"
 tagged A1-24, F23-24

Open in new window

This question needs an answer!

Become an EE member today

7 DAY FREE TRIAL

Members can start a 7-Day Free trial then enjoy unlimited access to the platform.

View membership options

Learn why we charge membership fees

We get it - no one likes a content blocker. Take one extra minute and find out why we block content.