• Status: Solved
  • Priority: Low
  • Security: Public
  • Views: 56
  • Last Modified:

Unable to validate connector O365

Hello,

I just finished deploying a Hybrid configuration for Office 365 and Exchange 2013. Everything went fine but when I validate my outbound connector it fails with the following error:
450 4.4.316 Connection refused [Message=Socket error code 10061]
[LastAttemptedServerName=owa.glaciercap.com] [LastAttemptedIP=12.184.1.88:25] [CY1NAM02FT039.eop-nam02.prod.protection.outlook.com]

I white-listed all the EOP IPs in our firewall so I'm not sure why this is happening. Did I miss something?
0
Kenny Placido
Asked:
Kenny Placido
  • 2
1 Solution
 
timgreen7077Exchange EngineerCommented:
Is it pointing to your MX record IP address? If not, point it to your MX record name or IP of your MX record.
0
 
Kenny PlacidoSr System AdministratorAuthor Commented:
I figured that it was my firewall. We opened it up to the internet and it worked.
0
 
timgreen7077Exchange EngineerCommented:
Good deal.
0
Question has a verified solution.

Are you are experiencing a similar issue? Get a personalized answer when you ask a related question.

Have a better answer? Share it in a comment.

Join & Write a Comment

Featured Post

Ultimate Tool Kit for Technology Solution Provider

Broken down into practical pointers and step-by-step instructions, the IT Service Excellence Tool Kit delivers expert advice for technology solution providers. Get your free copy now.

  • 2
Tackle projects and never again get stuck behind a technical roadblock.
Join Now