Donna Johnson
asked on
uploading a modified config file
14-router-1-confg14-router-1.txt
I need to configure some new routers (layer 3 switches: Catalyst 3560-CX). We have a few sites that already have them so I copied the config for one of them and modified it for the site the new router will be on. I have logged into the new router and done basic configuration so I can copy the modified file over using TFTP. Is there any settings I need to remove and add manually? I'm attaching a copy of the new config that I will be uploading (14-router-1) and the current config (14-router-1-confg). Any advice or input would be greatly appreciated.
Regards,
DJ
I need to configure some new routers (layer 3 switches: Catalyst 3560-CX). We have a few sites that already have them so I copied the config for one of them and modified it for the site the new router will be on. I have logged into the new router and done basic configuration so I can copy the modified file over using TFTP. Is there any settings I need to remove and add manually? I'm attaching a copy of the new config that I will be uploading (14-router-1) and the current config (14-router-1-confg). Any advice or input would be greatly appreciated.
Regards,
DJ
No config attached.
ASKER
I just up loaded them again. Please let me know if you can see them.
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
Thank you