Programming Rasberry Pi with RAD Stidio

Roger Alcindor
Roger Alcindor used Ask the Experts™
on
I am considering using a Rasberry Pi as an SBC (single board computer) with Android O/S installed and programming with Embarcadero RAD Studio 10.2  (C++ builder). Is there a library or other means of using the GPIO of the Rasberry Pi and other hardware features of the SBC ?
Comment
Watch Question

Do more with

Expert Office
EXPERT OFFICE® is a registered trademark of EXPERTS EXCHANGE®
Software Developer / Linux System Administrator / Managing Director
Commented:
I am not aware of a specific library but there has been coverage of this on Embarcadero's forums and they posted some videos etc. One that I found was here: https://www.youtube.com/watch?v=f_Wjqin9SXU

Some generic coverage of working in C++ with GPIO can also be found here: http://hertaville.com/introduction-to-accessing-the-raspberry-pis-gpio-in-c.html and the slides from the above video appear to be here: https://docs.google.com/presentation/d/1bdfuji14gSpQw1RKfmKlRsH4xf_ACKvXvlUn-Tkuy2Q

Sorry that this is not much to go on, but it may get you started.

Author

Commented:
Thanks for your comments Martyn, I shall be looking into this further in the months to come.

Roger

Do more with

Expert Office
Submit tech questions to Ask the Experts™ at any time to receive solutions, advice, and new ideas from leading industry professionals.

Start 7-Day Free Trial