asked on 10/15/2018

Nutanix cluster ip address change - how to without using IPv6.

I have a Nutanix / Dell 3 node environment, I have managed to change the host Ip addresses to a new subnet and I have also change the CVM ip addresses, but I am having problems finding a way to either change the Cluster IP address from the CLI or break the cluster and rebuild with new IP and name. Can anyone help? I am not that conversant with Linux so a simple explanation if possible to get this done.

Many thanks

E.

Node.js Linux Dell * Nutanix JavaScript

Last Comment

Eric

10/17/2018

Kaffiend

10/15/2018

Can you not do this from Prism (the GUI web-console management tool)?

Eric

10/16/2018

ASKER

HI Kaffiend, I am unable to start Prism, and now when I go to the CLI to get cluster status it says the cluster is still in reconfigure mode - and the instruction for getting it out of reconfigure does not find the relevant file. So I am stuck
.

Regards

E.

ASKER CERTIFIED SOLUTION

Kaffiend

10/17/2018

THIS SOLUTION IS ONLY AVAILABLE TO MEMBERS.

View this solution by signing up for a free trial.

Members can start a 7-Day free trial and enjoy unlimited access to the platform.

See Pricing Options

Start Free Trial

Eric

10/17/2018

ASKER

Hi, I have raised a call with Nutanix, but I try to figure these things out as it helps me understand my systems better when other things go wrong.

The error I was getting was: no such file , however I have logged on this morning to and run the command and it was successful - how very odd! ---- I have found the reason - the command I read had a "c" on the end - I now realise the formatting of the document had moved the point letter to the end of the command reconfigure. A simple typo!

Thank you for getting me to check the command.

The cluster is up, and I have access to Prism now yay.

Eric

10/17/2018

ASKER

Hi, Many thanks for your help, it helped me review what I had done and correct the incorrect command.

Best regards

E.