smart Z
asked on
static routing is not working
Hello Experts,
I have 2 sites connected via OSPF neighbor relationship using MPLS and I also have direct connect between the two sites. I had issue with the point to point connection and I removed the static routes between the two sites and OSPF was able to pick the routes again.
Now my Point - to - point connection is up again and I added the static routes but the issue I have now is that the traffic is still going through the ospf and not using the point-to-point path.
How can I make sure the path is reverting back to the point-to-point path, I thought by adding the static path it would pick it up again.
Thanks,
I have 2 sites connected via OSPF neighbor relationship using MPLS and I also have direct connect between the two sites. I had issue with the point to point connection and I removed the static routes between the two sites and OSPF was able to pick the routes again.
Now my Point - to - point connection is up again and I added the static routes but the issue I have now is that the traffic is still going through the ospf and not using the point-to-point path.
How can I make sure the path is reverting back to the point-to-point path, I thought by adding the static path it would pick it up again.
Thanks,
SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
I will give you all points for your comments.