jmachado81
asked on
Change IQN on esxi 6.5
How do I update the IQN names on esxi 6.5? I updated the name under storage adapters and tried via esxcli, but a reboot appears to revert my changes. Any thoughts?
It's not really supported, but you can directly edit the esx.conf (from the bash prompt).
ASKER
I looked at the file and the iqn name is correct which tells me that a reboot reverts it. Could there be another location to update it?
[root@server:/etc/vmware] cat esx.conf | grep cisco:
Could i create a new vmhba adapter with the correct information then delete the old one? I'm unsure if that would crash my host (which would be in maintenance mode if i attempted it).
[root@server:/etc/vmware] cat esx.conf | grep cisco:
Could i create a new vmhba adapter with the correct information then delete the old one? I'm unsure if that would crash my host (which would be in maintenance mode if i attempted it).
remember there are two partitions on the ESXi installation.
is this installation on a flash drive ?
is this installation on a flash drive ?
ASKER
How do I access the other partition? This is booting from iscsi off a netapp.
Boot from SAN ?
ASKER
Yes
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.