David
asked on
mpls ebgp vrf route distinguisher and route target
i set up a network with 5 routers, a CE, a PE, a P, a PE, and a CE
between CE <-> PE i set up ebgp on both sides
i set up the ip vrf companyname vrf process and set route targets
i got the eBGP adjancies up and running .. got the vrf special interfaces configured on the PEs
and then i found out i addressed the route distinguisher and route target incorrectly, so, i deleted the vrf process (no ip vrf) in order to change the RD and RT, but it was too late
my bgp sessions came down
how do i get them back up
does everything haev to go in order?
can i clear ip bgp ( i already tried and nothing happened)
thanks
-dave.j
between CE <-> PE i set up ebgp on both sides
i set up the ip vrf companyname vrf process and set route targets
i got the eBGP adjancies up and running .. got the vrf special interfaces configured on the PEs
and then i found out i addressed the route distinguisher and route target incorrectly, so, i deleted the vrf process (no ip vrf) in order to change the RD and RT, but it was too late
my bgp sessions came down
how do i get them back up
does everything haev to go in order?
can i clear ip bgp ( i already tried and nothing happened)
thanks
-dave.j
SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
worked.
thanks