Sonicwall Analyzer no menu

Leigh Kalbli
Leigh Kalbli used Ask the Experts™
on
I have installed SOnicwall Analyzer 7.2 appliance and set up the network settings.  Once logged in, under the "Firewall" section where i should be able to add a unit, there are no menus to do so.  Has anyone seen this?
Capture.PNG
Comment
Watch Question

Do more with

Expert Office
EXPERT OFFICE® is a registered trademark of EXPERTS EXCHANGE®
Director, Information Systems
Commented:
I can't say I've seen this particular issue, but I would either try:
1) a different browser and/or
2) make sure all my browser's anti-spam/anti-malware products whitelisted the page or were turned off.

I expect some javascript or framed content is being blocked.
Most likely Java - most browsers nowadays are not java-friendly.  Give Maxthon browser a try.
Another thing to try is to clear java caches on your computer and on the appliance via techsupport page.  Instructions in the link below
https://www.sonicwall.com/en-us/support/knowledge-base/170502255061941

Author

Commented:
Turns out Java was in fact the Issue. The newer chrome would not allow java to load everything

Do more with

Expert Office
Submit tech questions to Ask the Experts™ at any time to receive solutions, advice, and new ideas from leading industry professionals.

Start 7-Day Free Trial