Rodrigo Mello
asked on
After migrate to windows 10 - map drivers are disappearing
Hello all,
Probably some of you have already experienced that so could you help me ?
Im in a project and we are migrating windows 7 to windows 10. After the migration, map drivers are disappearing . Some considerations :
1 - In windows 7 it is not happening.
2 - Map drivers are being applied by GPO
3 - Map Driver GPO is set as Replace and Reconnect field are not checked.
Could someone let me know if it is a known Microsoft issue and if there is a solution or even a good workaround ?
Thanks and Regards.
Probably some of you have already experienced that so could you help me ?
Im in a project and we are migrating windows 7 to windows 10. After the migration, map drivers are disappearing . Some considerations :
1 - In windows 7 it is not happening.
2 - Map drivers are being applied by GPO
3 - Map Driver GPO is set as Replace and Reconnect field are not checked.
Could someone let me know if it is a known Microsoft issue and if there is a solution or even a good workaround ?
Thanks and Regards.
Map drivers are being applied by GPOScript or Preferences? Use Preferences if not already
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
Did you do an in-place upgrade from Windows 7 or install fresh? If upgrade, run a Windows 10 Repair Install.
https://www.microsoft.com/en-us/software-download/windows10
Windows 10 is running, so click on the Download button (not Upgrade Button, select Save.
Create a USB Windows Installation key and then run Setup on the USB Key.
This will launch the Repair and proceed normally