jskfan
asked on
Network Type POINT_TO_MULTIPOINT and POINT_TO_MULTIPOINT Non_Broadcast
Network Type POINT_TO_MULTIPOINT and POINT_TO_MULTIPOINT Non_Broadcast
I have configured a serial interface with IP OSPF Network POINT_TO_MULTIPOINT then later with POINT_TO_MULTIPOINT Non_Broadcast, then I realized in both cases when I run : show ip ospf interface s0/0, I see Network Type POINT_TO_MULTIPOINT[/b] only, there is no Non_Broadcast keyword added.
Any idea ?
Thanks
R1#sh ip ospf inte s0/0
Serial0/0 is up, line protocol is up
Internet Address 123.0.0.1/24, Area 0, Attached via Interface Enable
Process ID 1, Router ID 1.1.1.1, Network Type POINT_TO_MULTIPOINT, Cost: 64
I have configured a serial interface with IP OSPF Network POINT_TO_MULTIPOINT then later with POINT_TO_MULTIPOINT Non_Broadcast, then I realized in both cases when I run : show ip ospf interface s0/0, I see Network Type POINT_TO_MULTIPOINT[/b] only, there is no Non_Broadcast keyword added.
Any idea ?
Thanks
R1#sh ip ospf inte s0/0
Serial0/0 is up, line protocol is up
Internet Address 123.0.0.1/24, Area 0, Attached via Interface Enable
Process ID 1, Router ID 1.1.1.1, Network Type POINT_TO_MULTIPOINT, Cost: 64
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
Thank you
ASKER
but with : Show ip OSPF interface Serial 0/0 it is hard to know if it it configured as :
POINT_TO_MULTIPOINT OR POINT_TO_MULTIPOINT Non_Broadcast