Lani Vriezema
asked on
Crystal Report and Sage
How do you redirect crystal report to pull the information from the current company file you are in Sage?
ASKER
Mike,
Yes, I am running the reports from sage. My problem the report does not want to pull the data from the company file that is open in Sage.
I made sure I had the following formula in my report to redirect the report to pull the data from whichever company file is open. I am on version 18.
tsDataFolder:
"c:\tsData"
TsDesignMode
"SDesc"
Yes, I am running the reports from sage. My problem the report does not want to pull the data from the company file that is open in Sage.
I made sure I had the following formula in my report to redirect the report to pull the data from whichever company file is open. I am on version 18.
tsDataFolder:
"c:\tsData"
TsDesignMode
"SDesc"
I don't know anything about how Sage runs reports.
Is this a standard report they provided?
Does the report always pull from the same company?
mlmcc
Is this a standard report they provided?
Does the report always pull from the same company?
mlmcc
ASKER
Mike,
It used to until Sage went to version 17
It used to until Sage went to version 17
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
Can you open the report in Crystal and look at the report filter?
mlmcc
mlmcc
ASKER
I built the report in crystal.
ASKER
It had to do with the TsDesignMode formula. I was able to figure it out. Thank you for your assistant.
DId you create the reports?
mlmcc