CISCO 1900 ROUTER afterrebooted all interfaces are set to Shutdown state.
cisco 1900 router afterrestarted the interfaces are set to shutdown. All the configurations are correct but all interfaces are set to shutdown so I have to console into each interface and set to "No Shutdown" When I view the start config it is set correctly although doing the copy start run command does not resolve. Any help would be much appreciated.
sorry - this command
show version | inc register
show version | inc register
ASKER
Great. Thank you. I am traveling right now. I will post a little later. Thanks again for your quick response
ASKER
Configuration register is 0xC1
thanks again. above is the result of the command you asked for.
thanks again. above is the result of the command you asked for.
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
DE_Phone_Router#show ver | inc register
Configuration register is 0xC1 (will be 0x2102 at next reload)
DE_Phone_Router
I ran the commands you asked. Thank you
Configuration register is 0xC1 (will be 0x2102 at next reload)
DE_Phone_Router
I ran the commands you asked. Thank you
okay reboot the router and you should be all set.
The long and short of what you have going on is the boot register is pointing to a different area of mem than where your startup config is currently stored. At the reboot, you should load the startup config.
The long and short of what you have going on is the boot register is pointing to a different area of mem than where your startup config is currently stored. At the reboot, you should load the startup config.
ASKER
that worked perfect. thanks so much for your help
no worries. cheers
show run | inc register