kabrutus
asked on
Limit bandwidth per port Cisco switch
I am looking to limit the bandwidth on a per port basis. I have a Cisco switch 2960-s.
I would like to limit the bandwidth on a port to 15mbps up/down.
I have 100mbps line from my provider with multiple public IPs. I need to provide one of my clients a static public IP and I want to limit that IP/power to 15mbps.
Is this possible with the Cisco 2960-s?
I would like to limit the bandwidth on a port to 15mbps up/down.
I have 100mbps line from my provider with multiple public IPs. I need to provide one of my clients a static public IP and I want to limit that IP/power to 15mbps.
Is this possible with the Cisco 2960-s?
One option might be to just set the port to 10Mb, full duplex. Not quite the 15Mb you wanted, but definitely limited to 10up 10down.
ASKER
Yes, I thought of this. Need 15/15 and other times 25/25
You can do it Policy maps/class maps (QOS).
And add this class to the ports.
So if port is 100/100 . set it to 15% and so on.
Switch(config-pmap-c)#band width ?
<1-2000000> Kilo Bits per second
percent % of total Bandwidth
remaining percent/ratio of the remaining bandwidth
https://community.cisco.com/t5/routing/qos-bandwidth-limit/td-p/2677251
And add this class to the ports.
So if port is 100/100 . set it to 15% and so on.
Switch(config-pmap-c)#band
<1-2000000> Kilo Bits per second
percent % of total Bandwidth
remaining percent/ratio of the remaining bandwidth
https://community.cisco.com/t5/routing/qos-bandwidth-limit/td-p/2677251
ASKER
Is this done in the switch or router? I need it done on the switch.
Tried do this under switch interface:
srr-queue bandwidth "amount" ?
srr-queue bandwidth "amount" ?
This question needs an answer!
Become an EE member today
7 DAY FREE TRIALMembers can start a 7-Day Free trial then enjoy unlimited access to the platform.
View membership options
or
Learn why we charge membership fees
We get it - no one likes a content blocker. Take one extra minute and find out why we block content.