sccm deployment from Stand-alone error
Hi
My Company use sccm 1809 system to deploy OS to workstation
in the last month we got new vendor type of workstation ( lenovo thinkcenter 720s)
When we made OS Windows 10 deployment from Stand-alone media Driver Package was not install
and the Deployment OS came up without network and chipset, i got the following error when check the smsts.log
set drivers
My Company use sccm 1809 system to deploy OS to workstation
in the last month we got new vendor type of workstation ( lenovo thinkcenter 720s)
When we made OS Windows 10 deployment from Stand-alone media Driver Package was not install
and the Deployment OS came up without network and chipset, i got the following error when check the smsts.log
set drivers
Steve Harris
Sorry the text you wrote above is a little hard to read. Are you saying that you built an OS image for deployment and put the device drivers on that image? Or that you used out of the box setup and it wont connect to your management point?
ASKER
I said the i tried to install Win 10 OS via SCCM stand alone deployment and in the task sequence i add driver package for the new computer vendor and when i made the deployment on the new computer the drivers not installing
the deployment should run offline from stand-alone installation media without connection to SCCM management point
the deployment should run offline from stand-alone installation media without connection to SCCM management point
Hi,
I am going on a limb here but am going to say the network drivers are missing from the OS. Enable F8 command prompt (if not already) and type Ipconfig during the fail stage and see if there's an IP.
Mike
I am going on a limb here but am going to say the network drivers are missing from the OS. Enable F8 command prompt (if not already) and type Ipconfig during the fail stage and see if there's an IP.
Mike
ASKER
that the issue the driver missing , when i check the network status via F8 i don't get valid IP
how i can push network driver to this deployment ?
i already add the drivers package to the task sequences
how i can push network driver to this deployment ?
i already add the drivers package to the task sequences
How are your drivers added in the task sequence? Did you script them to filter for a specific driver, or did you have it "auto select" the best driver?
IE: I broke down mine (to an extreme level, you dont have to do this much) but each model has its own task sequence, and driver packages are all filtered by model as well. Hence when I make a sequence I allow only the drivers of that model via the categories feature (see image below)
I tried using best match, and it failed 80% of the time, not installing the correct driver.
Capture.PNG
IE: I broke down mine (to an extreme level, you dont have to do this much) but each model has its own task sequence, and driver packages are all filtered by model as well. Hence when I make a sequence I allow only the drivers of that model via the categories feature (see image below)
I tried using best match, and it failed 80% of the time, not installing the correct driver.
Capture.PNG
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.