compdigit44
asked on
Creating Static Cisco Port Channel
It has been a while since I create a static port channel on a Cisco 4500 and want to make sure I am doing it correctly
Port-Channel Requirements
Ports: TE 1/12 and TE 1/19
Mode: on (static)
I know you can do a config t group and list a range of interface to configure at once, but how can I setup a port channel when the ports are not consecutive? Also when done, how can I add a description to the new port channel. It is the same method for adding a description to a regular interface?
Port-Channel Requirements
Ports: TE 1/12 and TE 1/19
Mode: on (static)
I know you can do a config t group and list a range of interface to configure at once, but how can I setup a port channel when the ports are not consecutive? Also when done, how can I add a description to the new port channel. It is the same method for adding a description to a regular interface?
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
Correct
ASKER