Dan
asked on
port channel speed problem between cisco switch and synology NAS
I have cisco switch, a 3850 and created a port channel for 3 ports. Each port is a 10G port. On the other side, I'm using a synology with 4 (1G) ports. I did a LACP on that side as well and bonded 3 of the ports. It shows the link at 3000 Mbps.
On the cisco switch, the port channel shows a speed of a-1000
Not sure why it's only connecting at 1000, but when I did a speed ?, it only gives me the options of 10, 100,1000, auto and nonegotiate. I tried auto and it puts it back to a-1000. I tried nonegotiate and it didn't take that command. So how do I get the port channel to run at 10G, so it can at least transfer at 3G?
On the cisco switch, the port channel shows a speed of a-1000
Not sure why it's only connecting at 1000, but when I did a speed ?, it only gives me the options of 10, 100,1000, auto and nonegotiate. I tried auto and it puts it back to a-1000. I tried nonegotiate and it didn't take that command. So how do I get the port channel to run at 10G, so it can at least transfer at 3G?
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER