Murty M
asked on
Citrix ADC VPX 1000 Management CPU always using 100%. As per the below carlstalhood article, we can change CPU Yield to YES from Default. But this change required VPX 200 and lower only. If I do the s
Citrix ADC VPX 1000 Management CPU always using 100%. As per the below carlstalhood article, we can change CPU Yield to YES from Default. But this change required VPX 200 and lower only. If I do the same change on VPX 1000, is it effective? or is it hamper VPX performance? Please suggest.
NetScaler 12 packet engine consumes 100% of the hypervisor CPU. VPX 200 and lower only have one packet engine, so it’s probably consuming around 50% CPU.
https://www.carlstalhood.com/netscaler-12-system-configuration/#100cpu
Citrix ADC VPX packet engine consumes 100% of the hypervisor CPU. VPX 200 and lower only have one packet engine, so it’s probably consuming around 50% CPU.
https://www.carlstalhood.com/system-configuration-citrix-adc-13/#100cpu
https://support.citrix.com/article/CTX229555 -- is also recommending the same setting change. But not given any supported VPX Version.
NetScaler 12 packet engine consumes 100% of the hypervisor CPU. VPX 200 and lower only have one packet engine, so it’s probably consuming around 50% CPU.
https://www.carlstalhood.com/netscaler-12-system-configuration/#100cpu
Citrix ADC VPX packet engine consumes 100% of the hypervisor CPU. VPX 200 and lower only have one packet engine, so it’s probably consuming around 50% CPU.
https://www.carlstalhood.com/system-configuration-citrix-adc-13/#100cpu
https://support.citrix.com/article/CTX229555 -- is also recommending the same setting change. But not given any supported VPX Version.
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.