HP DL380 Raid controller issue

Afternoon,

What generation server is this? During boot you should see the  HP smart Storage Administrator pop up too, I.E it'll tell you to hit another key. I think it's F10

If that's been disabled

Reboot the server and when prompted, press F9 to access the UEFI System Utilities.

From the System Utilities screen, select System Configuration > BIOS/Platform Configuration(RBSU) > Server Security > Intelligent Provisioning (F10 Prompt) and press Enter

Select Enabled.

Save changes.

It may be even older in which case you would use the ACU under SmartStart.

its a DL380 gen8 will give that a go and revert back to you.

I think that's still valid for a Gen 8, I don't have one to spin up and check though :(

Gen 8 is F10 then select maintenance.

Does it look like this? If so then F5 maybe.



Pictures of your boot sequence would be nice.

Thanks
Alex

Alex it does look like the image but that just gets me to the array config and if i try and delete the volume it give the Notice, I have mounted the offline iso hpssaoffline and deleted do will not play around to see why no f10 thanks all for your help


Ryan

IP missing could be the iLO flash being corrupt, there is a "format nand" button under the iLO after which you can reinstall IP.

Alex it does look like the image but that just gets me to the array config and if i try and delete the volume it give the Notice, I have mounted the offline iso hpssaoffline and deleted do will not play around to see why no f10 thanks all for your help


Ryan

I'm not sure if you still have an issue or not from this post, could you please update.
Thanks
Alex