pramod khadka
asked on
SCCM client installation failed
I am installing sccm client to Windows 7 PC to get them upgraded to windows 10. I am getting error when doing so. I have tried client push and manual installation, on windows 10 it works fine but issue remains in windows 7 32 bit and 64 bit. My sccm is running version 1906 and site version 5.0.8853.1000.ccmsetup.txt.
Please see the log file for more details.
Please see the log file for more details.
ASKER
yes the logs are edited to hide my true domain name. Going through logs i noticed it was unable to communicate with MP and DP so i ran cmd specifying management point and sitecode, still no luck.
Could this be a firewall issue?
Could this be a firewall issue?
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
No comment has been added to this question in more than 21 days, so it is now classified as abandoned.
I have recommended this question be closed as follows:
Accept: 'Mike T' (https:#a43042000)
If you feel this question should be closed differently, post an objection and the moderators will review all objections and close it as they feel fit. If no one objects, this question will be closed automatically the way described above.
seth2740
Experts-Exchange Cleanup Volunteer
I have recommended this question be closed as follows:
Accept: 'Mike T' (https:#a43042000)
If you feel this question should be closed differently, post an objection and the moderators will review all objections and close it as they feel fit. If no one objects, this question will be closed automatically the way described above.
seth2740
Experts-Exchange Cleanup Volunteer
Hi, the log shows you have a proxy set in IE with domain A.B and then tries to use that to autodetect the proxy a 2nd time and fails. Then it fails to get the DP from the MP at which point it's game over.
Have you sanitised the log to say the domain is domain.local?? I hope, yes.
Mike