jskfan
asked on
ConfigurationWrapper.bat in SCCM
ConfigurationWrapper.bat in SCCM
In the Video below length is 12:42 , you can forward to 11:22. The other edited Task Sequence and in the Command line field he puts: ConfigurationWraper.bat
I am not sure what it is. I know.bat is a Script, but I he did not mention anything about that script.
Any clarifications?
Thank you
https://www.youtube.com/watch?v=9rNVKTs97xg
In the Video below length is 12:42 , you can forward to 11:22. The other edited Task Sequence and in the Command line field he puts: ConfigurationWraper.bat
I am not sure what it is. I know.bat is a Script, but I he did not mention anything about that script.
Any clarifications?
Thank you
https://www.youtube.com/watch?v=9rNVKTs97xg
Look in the package source the tool created. You should be able to open the .bat file to see what it calls.
ASKER
Look in the package source the tool created. You should be able to open the .bat file to see what it calls.
Which Package Source Tool ? and where is this located ?
After Dell Command Configure and Integration Suite is installed the physical files and folders are located here:
I looked for configurationWrapper.bat, but cannot see it:
ASKER
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
Thanks Adam...Probably you are Right...Something Going on in SCCM for Now...I will check SCCM in 15 minutes and follow your advice and give you feedback
Thank you Again
Thank you Again
ASKER
Thanks Adams..
Sorry for the confusion, The task I was doing is different than what was done in that specific video... I will post a Question whenever I do the Task similar to what was shown in that video.
Thank you Again
Sorry for the confusion, The task I was doing is different than what was done in that specific video... I will post a Question whenever I do the Task similar to what was shown in that video.
Thank you Again
Hi there! I do not have the Dell Command Configure integration for SCCM which creates the above mentioned batch file (ConfigurationWrapper.bat) could you please post the content of that file so that I can re-create it for my program? I have generated the executable for the setting I want (BlockSleep) and am curious if it is literally just calling out the executable in a batch file with no other settings.
Thanks!!!
Thanks!!!