asked on

QZDASOINIT jobs running at priority 20, but should be 50 according to JOBD, SBSD, RTGE, and CLASS

Hello,

I cannot figure out what is wrong. QZDASOINIT jobs are running at priority 20, but should be 50 according to JOBD, SBSD, RTGE, and CLASS. JOBD has RTGDTA of QCMDI, but there is no matching value in Route definitions in QUSRWRK SBS, so 9999 with compare ANY should be used and priority 50. Am I missing something?

Thanks,
Michael

Gary Patterson, CISSP

There are alternate mechanisms for routing qzdasoinit jobs. By user name, by source IP.

https://www.ibm.com/support/pages/routing-connections-subsystems-based-user-id

https://www.ibm.com/support/pages/host-server-customization-routing-connections-ip-address

Michael

ASKER

Hi Gary,

Thanks for your response. I was aware of the 7.1 enhancement, and I am planning to implement. But my problem is I cannot determine why or how the jobs are being assigned Priority 20 in the current configuration. I wanted to have a handle on the system's behavior before implementing the Re-Routing mentioned in the Web pages. See below:

ALL QZDAOINIT jobs (PJ and BCI) use QDFTSVR JOBD

JOBD - QDFTSVR - RTGDTA = QCMDI

QUSRWRK Routing Entries

Seq Nbr Program Library Compare Value

10 QCMD QSYS 'RUNPTY07'

20 QCMD QSYS 'RUNPTY10'

30 QCMD QSYS 'RUNPTY20'

40 QCMD QSYS 'RUNPTY25'

50 QCMD QSYS 'RUNPTY35'

60 QCMD QSYS 'RUNPTY50'

2210 QSCWCMON QSYS 'WATCHEVENT'

2211 QSCLICEV QSYS 'WATCHLICEVENT'

9999 QCMD QSYS *ANY

Subsystem description: QUSRWRK Status: ACTIVE

Routing entry sequence number . . . . . . . : 9999
Program . . . . . . . . . . . . . . . . . . : QCMD
Library . . . . . . . . . . . . . . . . . : QSYS
Class . . . . . . . . . . . . . . . . . . . : QSYSCLS50
Library . . . . . . . . . . . . . . . . . : QSYS

Class . . . . . . . . . . . . . . . . . . . . . . : QSYSCLS50
Library . . . . . . . . . . . . . . . . . . . . : QSYS
Run priority . . . . . . . . . . . . . . . . . . : 50
Time slice in milliseconds . . . . . . . . . . . : 2000
Eligible for purge . . . . . . . . . . . . . . . : *YES
Default wait time in seconds . . . . . . . . . . : 30

Thanks,
Michael W.

ASKER CERTIFIED SOLUTION

Gary Patterson, CISSP

membership

This solution is only available to members.

To access this solution, you must be a member of Experts Exchange.

Start Free Trial