Trouble configuring 10G port on Cisco switch

I'm having trouble configuring 10G port on Cisco C3750X switch.  There is a C3KX-NM-10G network module installed which gives 2 10g ports and 2 1g ports.  I believe ports 2 and 4 can be used for 10g.  Port 2 currently is using 10g to connect to another wiring closet and there is nothing in port 4.  I am looking to connect my EMC backup appliance using the 10g port.  I am a novice when it comes to networking, especially stuff like this.  Interface TenGigabitEthernet1/1/2 is port 4 on the 10g module I would like to use.  Other than adding the vlan is there anything else i need to do?  I was hoping it would act as a regular port but only 10g.  
Forgive me if this sounds stupid.  I have researched this but I have not found anything that explains it well.

Current log :
!
interface GigabitEthernet1/1/1
!
interface GigabitEthernet1/1/2
!
interface GigabitEthernet1/1/3
 description Connected to xxxxx for uplink
 switchport trunk encapsulation dot1q
 switchport mode trunk
 srr-queue bandwidth share 1 25 20 45
 queue-set 2
 priority-queue out
 mls qos trust cos
 auto qos trust
!
interface GigabitEthernet1/1/4
!
interface TenGigabitEthernet1/1/1
 description Connected to xxxxx port T1/0/1 for uplink
 switchport trunk encapsulation dot1q
 switchport mode trunk
 srr-queue bandwidth share 1 25 20 45
 queue-set 2
 priority-queue out
 mls qos trust cos
 auto qos trust
!
interface TenGigabitEthernet1/1/2
!