SAM2009
asked on
How it needs to plug server with 10 Gb ports to a switch?
Hi,
I have a Dell server with 10 GB ports and I need to plug it to switch.
What confuse me is what should I verify or need to achieve that.
What is SPF+ module, direct-attached mean?
Can we just purchase a Rj-45 10 GB cable or SFP+ module is also required???
I have a Dell server with 10 GB ports and I need to plug it to switch.
What confuse me is what should I verify or need to achieve that.
What is SPF+ module, direct-attached mean?
Can we just purchase a Rj-45 10 GB cable or SFP+ module is also required???
Without knowing which server/NIC and switch you have it is impossible to say, several different connectors are available for 10GbE.
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
Consideration: To achieve this speed, your router + all other machines involved all require same speed ports/interfaced.
Just went through this with a client recently where he got everything working + speed was much lower than he imagined, because his switch didn't support speed of machine interfaces being connected.
Just went through this with a client recently where he got everything working + speed was much lower than he imagined, because his switch didn't support speed of machine interfaces being connected.
ASKER
So basically: The server and switch should have 10 GE SFP+ ports available.
The cable that can be used are:
- SFP+ module (2 at each side of cable) with Fiber cable
- Or Direct-Attached cable which are built with SFP+ at each side
Am I right?
The cable that can be used are:
- SFP+ module (2 at each side of cable) with Fiber cable
- Or Direct-Attached cable which are built with SFP+ at each side
Am I right?
DAC cables are generally cheaper, but limited to a few metres in length. You can turn the signal from electric to optic to electric again for longer distances using SFP+ transceivers and glass fiber but obviously easier to just use a twinax cable.
SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
Server and switch have: 10 GE SFP+
Then get a DAC cable or two SFP+ optics and a fiber patch.
Note that Cisco switches typically don't play very well with 3rd party modules that are not explicitly coded to be Cisco compatible.
Yup, try to connect a Juniper to a Cisco and you have to get the ROMs custom blown so Cisco sees a Cisco cable and Juniper sees a Juniper cable.
Bear in mind you can use 10GBASE-T SFP+ as well as DAC or fibre.
Bear in mind you can use 10GBASE-T SFP+ as well as DAC or fibre.
ASKER
Thanks