eemoon
asked on
Where can we configure it to increase the signal strength at C9800 wlc
Hi Signal strength in WLC C9800/AP 9130 is not strong. Where can we configure it to increase the signal strength? Thank you
SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
Thank you for your reply. Creating RF profile is one of ways for increasing signal.
But really there is another simple way to do it. In wlc gui, default is " 1 ", we can change to " 6 " as max. But i cannot find it in gui
Transmi power set is also option?
But really there is another simple way to do it. In wlc gui, default is " 1 ", we can change to " 6 " as max. But i cannot find it in gui
Transmi power set is also option?
ASKER
Please see the below. I found out something. When in Assignment Method change to Custom, we can change Tx Power Level. but I do not know under the same C9800, why we can only change it at AP9117, not AP9130, which cannot be changed to Custom due its grayed out in there
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
Yes, Thank you David. I like what you said above.
closer to area of interest