Avatar of Dek4
Flag for Belgium asked on

Network Interface driver not loaded during SCCM, Task Sequence, OSD

OSD with SCCM of a new model (new drivers...) but in middle of TS I loose nic drivers therefore the TS does not succeed apps not installed, system does join domain 

- I have no issue with other models, so TS is fine 

- At the beginning of TS nic drivers are loaded, image is installed even drivers based on model are installed, during that 1st part of TS when I hit F8 I can ipconfig and see IP

- Once the PC restart post to image applying and drivers installation when ever I hit F8 and ipconfig I see some WiFi adapters but no eth interface  

SCCMPCOS Deployment

Avatar of undefined
Last Comment

8/22/2022 - Mon
Michael Pfister

Intel NIC? Had to grab a current driver version for the driver package, otherwise had the same problems.
Partially had even problems during the WinPE phase, so I replaced it there as well.

Thanks Michael for your quick response. Figured it out at last... Issue was on Apply Drivers step in TS. Although all drivers NIC included were installed during driver installation step, Apply Driver step was required for this model.   

Log in or sign up to see answer
Become an EE member today7-DAY FREE TRIAL
Members can start a 7-Day Free trial then enjoy unlimited access to the platform
Sign up - Free for 7 days
Learn why we charge membership fees
We get it - no one likes a content blocker. Take one extra minute and find out why we block content.
Not exactly the question you had in mind?
Sign up for an EE membership and get your own personalized solution. With an EE membership, you can ask unlimited troubleshooting, research, or opinion questions.
ask a question
All of life is about relationships, and EE has made a viirtual community a real community. It lifts everyone's boat
William Peck