HP Procurve 2910al GUI down

ssh enabled? If yes try connecting from putty.

But I'm afraid to get the web GUI back a reboot is reqired. Check you're running the latest firmware.

Yes can putty to it.  I see the date/time is also wrong.

SRC:

Running configuration:

; J9148A Configuration Editor; Created on release #W.15.14.0016
; Ver #06:04.18.63.ff.35.05:b6
hostname "HP-E2910al-48G-PoE-"
module 1 type j9148a
logging severity info
power-over-ethernet pre-std-detect ports 4-48
qos type-of-service diff-services
sflow 1 destination 172.19.10.24
sflow 1 sampling 1-48 500
timesync sntp
sntp unicast
sntp server priority 1 87.124.126.49
sntp server priority 2 178.79.165.21
time timezone 60
ip authorized-managers 172.19.0.0 255.255.0.0 access manager
ip authorized-managers 172.16.0.0 255.255.0.0 access manager
ip authorized-managers 10.255.255.0 255.255.255.128 access manager
ip authorized-managers 192.168.2.0 255.255.255.0 access manager
ip authorized-managers 192.168.3.0 255.255.255.0 access manager
ip authorized-managers 10.255.254.0 255.255.255.128 access manager
ip authorized-managers 192.168.100.0 255.255.255.0 access manager
ip authorized-managers 192.168.200.0 255.255.255.0 access manager
ip authorized-managers 10.255.253.0 255.255.255.0 access manager
ip default-gateway 172.19.4.10
no ip icmp redirects
ip route 0.0.0.0 0.0.0.0 172.19.4.10
ip routing

is there a command to refresh/grab the date or manually set it?

Have manually set the time and tried to set a daylight time rule (not sure if correct way and if it works).

I can now login though.

  

So it's working now?

Sure is.